Security Alarms AR6000 Guide de l'utilisateur télécharger pdf (Page 34)

34 SPEKTRUM DX6 • AIRCRAFT PROGRAMMING GUIDE

WING TYPE SELECTION (CONTINUED)

















TO ACTIVATE FLAPERON (FPR) MIXING (WING TYPE MODE)

1. In System Setup mode, press the SCROLL button until “MIX WNG” appears on the screen.

2. Press the INCREASE button to activate Flaperon Mixing.

V-TAIL

V-Tail Mixing requires two servos, each connected to the right and left tail control surfaces. Connect the left tail

servo to channel #3 (ELE) and the right tail servo to channel #4 (RUD) in the receiver. Individual functions (e.g.,

servo reversing, sub-trims, etc.) are available for each servo. Use sub-trims for individual neutral adjustments

and to vary the up and down travel as desired by using the dual rate function to adjust elevator vs. rudder travel

independently.























TO ACTIVATE V-TAIL (VTL) MIXING

1. In System Setup mode, press the SCROLL button until “MIX WNG” appears on the screen.

2. Press the CHANNEL button once to access the V-Tail Mixing screen.

3. Next press either the INCREASE or DECREASE buttons once to activate V-Tail Mixing.

Note: It is also possible to activate both the Flaperon (FPR) and V-Tail (VTL) functions to work

simultaneously. While it is unlikely to have an aircraft that would require both, it is possible.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 95 96

Pas de commentaire

Security Alarms AR6000 Guide de l'utilisateur Page 34